The new swimming pool / pool water treatment

         Devices using new materials, equipment of up to 40 years

All inlet, outlet back, piping, valves, water treatment swimming pool cleaner are all in white water supply UPVC material made of white, beautiful, generous, non-corrosive. System has no wearing parts, no corrosion, no maintenance. From the fundamental solution to the problem of rusty water, and every year the problem of regular maintenance. Use of the water treatment system can reach four years.

The fine filter turbidity low

In the filtration process, mainly interception and adsorption. Swimming pool cleaner is used in different mineral aggregate multilayer composite filter layer composition from large to small, greatly enhances the retention filtering effect, while the surface layer of the membrane filter media can further adsorption of organic and inorganic substances. Smallest particle diameter of 0.15 mm filter media, far less than the traditional quartz sand, interception capability, the water quality is excellent. Turbidity can do 0.4 mg / liter, clear azure water, the turbidity of the water far below 3 mg / liter.

Specifically divided into the following steps:

1, the first to join copper sulfate, generally 1-2 times the usual amount, and this is because the algae in the water usually small, and the water green with algae exist, it must be added to a sufficient amount of algaecide (sulfuric acid copper) in order to fully kill the algae. Plus algicide (copper sulfate), it should open the swimming pool water circulation system that allows agents in the water as uniform as possible, and thus play the best results;

2, about two hours later, adding Swimming pool cleaner uric chlorine disinfectant, addition of 1,000 cubic meters of water by not adding 4kg standard dosing (usually per 1,000 cubic meters of water 2kg), which is what we usually talked about the impact of or super chlorination treatment, so that the water pool full of sterilization, disinfection;

3, about two hours later, the detection of water PH value, usually after the rain and the use of trichloroisocyanuric acid disinfectant chlorine, PH value of water will certainly be on the low side, so long as the use of squeeze raise adjust the PH value (caustic soda ) can improve water PH value, Holiday amount is 10kg per 1,000 cubic meters of water were added to improve a degree of calculated amount. Preferably the PH value was adjusted to 7.5;

4, in the evening holiday precipitant amount 5-8kg per 1,000 cubic meters of water as the standard, so you can be the water has been killing small algae and other suspended solids settle to the bottom of the pool; analysis from Sheung Shui environmental technology.

Why do I need a professional clean water tank cleaning and disinfection?

    swimming pool automatic cleaner  To clear pool of secondary water pressure and other settings, tanks vulnerable secondary pollution, bacteria, viruses, and other harmful substances bloodworms grow at an alarming rate. Public cloud seen cleaning the pool wall when the sludge, all surprised! Secondary water supply clean water tank, causing the tank water pollution has caused water quality experts, medical experts are highly valued. Contaminated water can lead to acute and chronic disease, long-term damage to human health, healthy drinking water without delay.
     These problems became public complaints hot. Some units when self-cleaning tanks, but with a broom to sweep away the moss reservoir, water reservoir wall erosion simple even completed the task of cleaning the reservoir, the reservoir did not disinfected, nor after cleaning the reservoir water quality inspection departments to get, in fact, this cleaning method does not ensure water quality standards reservoir. If the Swimming pool cleaner had infectious diseases, it may also cause water pollution. So, cleaning the reservoir should be in accordance with the relevant requirements and standards, in order to protect the public safety of drinking water. In the pool into the disinfectant, with a stiff brush to remove the wall, the bottom of the clear coating, fouling, wash dirty water will drain, sink, water tank in such a way are repeatedly washed three times to complete the clean side. After completion of the cleaning water quality testing center to apply for sample testing.

The latest professional cleaning robot for public swimming pools

swimming pool automatic cleaner is a compact, powerful cleaning ability, with a rotating brush cleaning robots. Per minute pump out 600 liters.
The device is available in three configurations:
Standard configuration for rectangular swimming pool cleaner line programmable
W50R, automatic cleaning, care computing during operation.
All three versions can also be controlled via radio remote control, arrived in the dead zone. The latest laser probe design enables automatic cleaning. W50 is based on the electric submersible pump, equipped with high-resistance steel impeller ensures reliable clean, hindered by large particles.

All pools must periodically need to clean the bottom of.

The Pool cleaner current solution is: first add calcium hypochlorite, the filter bypass (that is, only cycle, no filter), the purpose of the calcium hypochlorite fully mixed evenly, two hours later, turn off the filter, settling for 24 hours. After 24 hours, the reopening of filtration (filter state), with a long tube inserted into swimming pool cleaner, a bottom carpet along the road, this time, the bottom of the brown sludge and sediment disinfection will be sucked into the filter device and is filtered out. Because you did not say that is the end of your pool water or edge of the water, so I do not know if you should end when the suction tube is inserted in one end of the pool or the bottom. Or, in the overflow tank outlet, you can also look at the diameter size, with a diameter hose right, so do not pick up a tube of water. Hose and the other end tied to the root of a long-handled, standing beside the pool like the operation. After absorbing all the best day at the end, so that the dirt will not end up with the plot.

Swimming pool water cleaning methods and procedures:

① cast disinfectants --② adjust pH --③ vote cast precipitated drug --④ algae drug --⑤ vacuuming the entire pool of sewage water changes --⑥

① disinfectant - swimming pool cleaner tablets (one hundred eliminate net)
Can quickly kill intestinal bacteria, pyogenic bacteria, yeast and pathogenic virus can be inactivated. Efficacy and stability, long duration; sodium hypochlorite disinfection is 40 to 80 times, with less accurate measurement; easy to use, no residual poison and side effects were absolutely safe

②PH modifier - sodium hydroxide (caustic soda)
Adjusting the pH of the water quality

③ precipitating agent - Efficient PAC
PAC is actually an alumina, because of a mixture of aluminum chloride, which is mainly hydrogen chloride precipitation of alumina AL (OH) 2 precipitates, which is a micelle capable of impurities in the water inside or attached to the parcel which its surface, piled heavy and settle down in the water clarification.

④ pool algaecide - copper sulfate
For swimming pool water algae, to prevent all kinds of algae growth in water, such as algae, black algae, moss green growth and water.

⑤ vacuum sewage
The pellet in the bottom of the debris by suction sucker, then add fresh water.

⑥ entire pool of water changes
When the quality of the water has been unable to meet state water quality requirements, the need to change the water the entire pool. When changing the water, the dirt wall material, the bottom adsorption of brushing.